Syma Forum
Welcome to our Syma Forum - Please click on topics to view comments.You have to be a member to post-Free to join. Enter correct email as password will be emailed to you- All Syma Helicopter help and advice here. NEW- you can now change color of forum, bottom of page!
A A APlease consider registering
guest
Hi everyone. This is my old, slightly modified, go-to heli. Quite, fast, precise. It was my first and have had it since December. First the battery needed replacing. Ah, it was born again! Then the top rotor motor went out so I replace it. I know it was bad. After changing it it still won't get off the ground. I checked the gears, everything looked good, but it seemed rough to turn, like it was catching. Looked even more closely at the gears and everything looks good. So I changed the lower rotor motor and still won't get off the ground. Same problem. No change in behavior. I've re-done my soldering several times hoping I just didn't get it right or something. Any ideas?
Board?
Time for retirement?
Thanks!
Oh, and it was lubed with silicone, so that's not the problem. Unless I put too much and two weeks later it caused a problem.
Most Users Ever Online: 211
Currently Online:
12 Guest(s)
Currently Browsing this Page:
1 Guest(s)
Top Posters:
MikeK: 178
SymaGuru: 32
justdon: 9
nope: 5
smith: 2
groggy: 2
Member Stats:
Guest Posters: 729
Members: 20
Moderators: 0
Admins: 2
Forum Stats:
Groups: 7
Forums: 16
Topics: 1283
Posts: 8215
Newest Members:
Administrators: Syma Freak: 1452, JamDJ: 264