Syma Forum

I have run into an issue with my S107G It is an Original not a clone This I know.

I have owned my S107G for about 3 months now about 2 weeks ago My [A] top motor sheared off a wire

I was clueless how this happened. So I ordered 2 new motors. When I got them in I went to Bernie's you tube

video site, And the motor exchange went flawless not an issue.

Well 2 days ago I was flying my s107g and it quit no lights to nothing. So after some detective work

I discovered that my top motor [A] had spun and one of the wires was under the tab on the main frame

that holds the Motor from lifting.

I spin the motor with a pair of small needle nose pliers removing the wire from under the tab and again I was up and flying.

Well this lasted for about 6 flights and it did it again. So my question is do you have any ideas

on how to keep the 2 top motors from spinning and staying in place I am afraid I am going to shear off another wire.

And I really don't want to continue to replace top motors because the top motors keep spinning.

Any suggestions are more than welcome. I am at a dead end with this. I was going to super glue the main

frame tab to the motor but I don't think this is a good idea. Any one else had this issue??

Any one have any ideas on how to stop this from happening?

I am all ears.

Thanks

Rixh